@admin
Active 3 hours, 46 minutes agoForum Replies Created
-
AuthorPosts
-
Ben
Keymaster
Type: Equipment
Point Cost: 5
Ability: This equipment can only be used inside forts, never on ships. If the fort this equipment uses is destroyed, eliminate this equipment from the game.Once per round when an enemy non-submerged ship ends a movement segment within range of the Claw or is already in range of the Claw (within 1S perpendicular to a fort wall), you may use this equipment. The first time the Claw is used, place it into one of the 4 fort walls. Move the Claw into contact with the enemy ship; the affected ship must stop moving immediately (any remaining movement segments are lost), and cannot be given move actions until until the Claw is retracted or the fort is destroyed. When the Claw is moved into contact with an enemy ship, roll a d6. On a 6, eliminate three masts from the ship; the ship sinks if it has less than three masts remaining. On a 4-5, eliminate two masts from the ship. On a 2-3, eliminate one mast from the ship.
At any time during one of your turns, you may retract the Claw to break contact with an enemy ship. The Claw cannot be used on the same turn that a fort is built (because that play turn is over). The Claw may be moved from one wall of the fort to another – if there are crew in the fort, moving the Claw is a free action; if there are no crew in the fort, moving the Claw requires a full action and the fort cannot shoot or repair that turn.
Ben
KeymasterTalk Like A Pirate Day sale: Use coupon code TLAPD for 10% off any items in your order! (through tonight at 11:59pm PST)
Ben
KeymasterLatest template available: 1 Mast Sloop
Master Artwork Template folder (central location for all finished templates)
Ben
KeymasterFirst draft of new terrain: Shallow Water
Submerged game pieces cannot move or be moved into shallow water.
If a ship with 3 or more masts (when constructed) touches shallow water, she runs aground. Roll a d6; on a 1-2 eliminate a mast from the ship. When a ship is aground, one full action is required to free the ship; after the action ends, place the ship’s bow at the edge of this terrain; the ship can begin moving normally with her next move action.
If a ship sinks in shallow water, mark the spot where the ship sank with a hull silhouette piece and move the ship’s deckplate and any non-crew cargo to a neutral area; the ship and her non-crew cargo are not eliminated or removed from the game. Ships sunk in shallow water do not block lines of fire or measurement. Ships with 3 or more masts (when constructed) cannot be placed in contact with ships sunk in shallow water, nor can they move or be moved over them.
Example of appearance:

Ben
Keymastertrying to figure a value to put on it, and was hoping you guys could possibly help
Ahoy, Holofernes sold his with a few other things for $151 in 2021.
Ben
KeymasterSecond GS playtest game:
Ben
KeymasterFixed flavor text of Guichuan (DJC 300): hailed instead of “hauled”.
(saw it while making a replica of Guichuan)
Ben
KeymasterArshellan runs PSMList, he is probably most easily reached at the Pirates CSG Discord.
He just released an awesome update less than a week ago 🙂
Ben
KeymasterWill someone please enlighten me what the crew, treasure, and equipment do in the game?
Various effects; treasure is usually required to win the game. Full rules are at the bottom of the homepage if you don’t have them already.
Aren’t they just chits you place on islands and ships after they are punched out from their deck plates? I would assume their deck plates have the affect of the punched out chits? How does one keep track of it all?
Treasure goes on islands, crew and equipment usually go on ships. Yes, abilities are on the cards (usually a deckplate is only in reference to a ship’s main stat card, the first card of a ship). For tracking, just keep all the cards for your fleet in your designated spot on the table, likely with non-ship cards hidden away in a tin/etc so opponents can’t look over and see all your plans.
Ben
KeymasterI think I might get a Cameo 4 and some Styrene and try to cut out thd ships that way. I don’t know if you tried that first before 3D printing?
I’ve thought about it, but research made me doubt that it can work. From my online searches earlier this year, I saw that some Cameo 4 blades can cut up to .5mm styrene, but thicker could be problematic.
I recommend reading this post about the 3mm Kraft blade – I think it would struggle with some of the intricate cuts that the ship shapes consist of, and it sounds like more of a hassle than it would be worth.
However, I still haven’t tried to cut styrene with the Cameo 4, so I can’t say for sure that it can’t be done.
Ben
Keymaster(moved from the Intros thread)
I went to the store link to try and find the decals but was unable to locate them.
Ah, I think I misunderstood you. I’m selling finished products that people can use in games, not bulk supplies.
I have STLs for all of the ships but don’t know if they are already scaled to the ships in the game.
That can be a tricky element of it; they should be matched to the game’s scale but sometimes have minor differences. Which URL did you get the STL’s from?
How do you 3D print PLA? I only know of FDM.
FDM is what I use to print PLA.
Would it not be easier to use a Cricut instead?
That would be for cutting the decals, not 3D printing.
Ben
Keymasternow if we can just get someone to handle decals? If I had the expertise I would do it! Anyhow it is great to be back and I look forward to seeing the continued progress of this game for current generations to experience.
Ahoy, I am doing decals every week. Various products at the Store with more to come. 🙂
Ben
KeymasterNow available: Oak Island!
Especially for fans of The Curse of Oak Island TV show, this is the perfect thing to bring into your Pirates games! Could also work well with themed/region games such as New World discovery, American Revolution scenario, etc.
Ben
KeymasterAm I able to use a crew such as Screaming Mimi to pull opponents from a fog bank?
A move action is required to exit.
secondly regarding fog hopping, fog banks used by smokepot specialists are placed (not rolled for like other specialists) on that players turn but are removed before any actions are made on that same players following turn. If the players ships aren’t pulled from the fog before the start of that players next turn, is the ship removed from play when the fog bank is removed?
No, unless it doesn’t exit a fog bank that turn: (page 28 of the Code)
–When the fog bank is removed at the beginning of your turn, you may choose to roll and place this ship immediately (per normal the rules for smokepots) or you may choose to have it remain “inside” the fog. If it remains in the fog, the ship must exit another fog bank before the end of your turn; if it does not exit, it is removed from the game instead.
Ben
KeymasterNeat to see one with all 7 cannons. Aekel could be particularly nasty with some speed boosting, S-boarding while submerged – especially with nothing to lose.
Ben
KeymasterHopefully the following clears it up.
Looks good to me!
Ben
Keymastera leviathan can attack submerged ships.
I would clarify what this means – can shoot at submerged ships, can ram them, etc.
After winning a boarding action
I would change it to “boarding party”, but that’s more of just my opinion on it.
Does 30 points for the example leviathan feel fair or still too cheap for what the keyword can do as-is?
With the updated version, I think it could work now. I was most concerned about the possibility of getting pinned and having almost no recourse for it.
Ben
KeymasterA submerged Leviathan may ram another ship, the rammed ship becomes pinned instead, and it may board.
This troubles me – how is the pinned ship supposed to retaliate? It sounds like they can essentially be frozen in place indefinitely from the pin unless they can cancel the Leviathan keyword/etc.
I assume the “it may board” refers to the Leviathan? One could argue that is in reference to the rammed ship instead. Perhaps “A submerged Leviathan may ram and board another ship; the rammed ship becomes pinned instead.”
A lightning attack allows a Leviathan to attack any one target (regardless of its submerged status and including submerged ships) with a 2L range and rank of 2, measured from the cannon on the leviathan’s head.
Assuming I understand the intent clearly, this is how I would word it: “A lightning attack can be initiated even if the Leviathan is submerged, and allows a Leviathan a rank-2 attack against any one target (including submerged ships) within L+L of its head.”
This is assuming “its submerged status” is in regards to the Leviathan, because if it’s in reference to any enemy submerged ship, that part is already covered by the part in parentheses.
After a Leviathan resolves a move action, as a free action it may repair any one missing segment.
This is very powerful, I could see it doing this repeatedly after an engagement goes poorly. Just submerge and then repair for free en route to the next target… scary stuff!
If I understand it right, I just find the potential lack of counters slightly alarming. You could stay submerged, pin an enemy, and then slam them with lightning until they have no masts, risking nothing in the process unless they have Canceller or “shoot at submerged”/etc.
Ben
KeymasterBen
KeymasterPirates of the Golden Seas is now viewable on PSMList! (complete with full card gallery)
Ben
KeymasterI played a bit about 10 years ago, but I’m not going to pick this back up. I’m trying to figure out the correct / easiest way to sell these.
Are there some chase card lists I should double-check first then bulk sell? Something else? Open to ideas and suggestions. Cheers.
I would check Gladius’ price histories to see if you’ve got some of the valuable stuff. The most updated versions are in the Buy/Sell/Trade Facebook group for this game, which could also be a good place to sell stuff.
Ben
KeymasterAlmost never see these sealed anymore: PotC tins and a Treasure Chest tin (affiliate link)
Ben
KeymasterHere is the latest master artwork template – for full art custom crew.
To get the card background on the front to look right, line your card background up with the card dimensions, have it just underneath the Clipping Path in the layers panel, then go to Object>Clip>Set Clip to crop it to the pattern.
I don’t have all the crew chips with artwork bleed done yet, but they will be available in an Artwork Assets folder eventually
Ben
KeymasterPirates CSG Podcast #68: 3D Printing and Making Ships with Vulkan of CustomPiratesCSG!
Pirates CSG Podcast #68: 3D Printing and Making Ships with Vulkan of CustomPiratesCSG!
Vulkan is one of the modern legends of Pirates CSG, having pioneered a DIY method of producing both custom and replica ships via 3D printing and decaling. His efforts from 2021 and beyond have been instrumental in the game’s continuation. He was also a key collaborator in the development of Pirates of the Golden Seas, as his knowledge and expertise greatly helped shorten my learning curve and 3D printing troubleshooting.
Ben
KeymasterHere’s the full Direct Deposit gimmick fleet:
Ben
KeymasterBen
KeymasterDifferent Name, Title, or Spelling, Same Person
Addition to the No-Duplicates list:
“Cannonball” Gallows (MI) = Sean “Cannonball” Gallows (RotF)
Ben
KeymasterChanges since May:
Fixed spelling of Ms. Cheng (from “Mrs. Chang”) in flavor text for Grand Dynasty (SCS 001).
Changed USS Atlanta (OE 090) cannons from 3L-4L-2S to 2S-3L-4L.
Added treasure values to Scrye the Explorer (SM PP-375-C): 1,1,1,2,2,2,3,4,5,6
Changed keyword of HMN Rumbarrel (MI 212) from Mercenary to Turtle Ship.
Eliminated extra “is” from ability text for Dr. Forbes Beattie (CC 045), Doctor Urbano Javier (062), Father Rene Bordeaux (RV 064a and RV UL064a), and “Hacksaw” Riley (RV 097a and RV UL097a). Also added comma after “eliminated” for all of their ability texts. -
AuthorPosts
